Technical service specifications

Intralox services structured around rate, handshakes and cutover evidence

Service workstreams are specified as reviewable boundaries: what is modeled, what is tested, what is accepted on site and what remains owned by operations after handover. Response objectives stay project-specific because travel, spare access and isolation rules change the achievable recovery path.

Capability matrix

Service packages mapped to conveyor operating questions

Each package names the primary deliverable, the minimum input set and the evidence class it can support. Planning values are not published as certified performance claims.

Service packagePrimary engineering questionMinimum inputsEvidence class
Throughput validationDoes design rate hold across the sustained peak with stated mix, gaps and buffers?Order profile, carton/tote mix, peak duration, accumulation length, divert rulesScenario and sensitivity record
Controls responsibility matrixWho owns command, confirmation, timeout, alarm and restart for each handshake?WMS/WCS/WES/PLC message list and safety interlocksResponsibility matrix + FAT script
Brownfield cutover planningHow does live fulfillment stay protected during staged conveyor release?Zone map, fallback paths, commissioning windows, temporary trafficCutover and rollback plan
Lifecycle serviceabilityWhat spares, access and diagnostics keep mean time to repair within agreed exposure?Asset list, duty cycle, belt/sprocket criticality, local skill modelServiceability and spares matrix
Divert and merge readinessCan induction, gap control and reject paths survive irregular product quality?Product quality limits, photo-eye placement, recirculation capacityDivert exception playbook
Methodology

Five steps from operating data to acceptance gates

  1. Frame the operating profile

    Capture load units, SKU velocity, order-line distribution, peak window, temperature zones and the longest tolerable interruption for each critical conveyor path. Mark unknowns as assumptions with owners.

  2. Bound the conveying concept

    Relate belt or roller selection to friction, incline, washdown, elevation and accumulation. Separate greenfield freedom from brownfield column, mezzanine and dock constraints that change transfer geometry.

  3. Map controls ownership

    Document WMS, WCS, WES and PLC responsibilities for release, routing, confirmations, alarms and restart authorization before interface definitions freeze.

  4. Run scenario and FAT evidence

    Exercise baseline, peak and disturbance cases for divert failures, full zero-pressure accumulation and merge conflicts. Record expected versus observed states, divert accuracy samples and interface cycle-time timeouts for FAT-relevant handshakes.

  5. Close SAT and service handover

    Repeat applicable checks with installed geometry and real loads. Transfer diagnostics, critical spares guidance and recovery procedures with clear ownership after go-live.

Request a scoped service review

Send the data that defines available and accepted

Include the operating calendar, conveyor concept, interface list and the acceptance questions that must be closed before cutover. Assumptions can remain provisional if they are labeled.

Open the service brief